Circuit/System Verification

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the park assist system is enabled.
    • If the park assist system is manually disabled 

      Enable the system. Refer to the vehicle owners manual for instructions on enabling the system.

    • Go to next step: If the park assist system is enabled 
  3. Transmission in REVERSE.
  4. Verify the scan tool Park Assist System Status parameter is Enable.
    • If the parameter is not Enabled 

      Refer to Diagnostic Aids  to determine the cause of the inhibit.

    • Go to next step: If the parameter is Enabled 
  5. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.