Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The object sensors are 3-wire ultrasonic sensors that are used to determine the distance between the vehicle and an object. The Parking Assist Control Module supplies 12 V to the object sensors via the 12 V reference circuit and provides ground via the low reference circuit. The Parking Assist Control Module triggers the sensors in a sequential loop. After each sensor transmits, the Parking Assist Control Module uses the sensor echo received through the signal circuit to calculate the distance and position of an object.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.