Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 110 (PARKING ASSISTANCE SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B095D OR B095ECIRCUIT/SYSTEM DESCRIPTION
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Circuit/System Description
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Circuit/System Description
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
| Circuit | Description |
|---|---|
| 8 to 12 V Reference | Regulated voltage supplied by the control module. |
| Signal | 8 to 12 V Reference |
| Low Reference | Grounded through the control module. |
| Component | Description |
|---|---|
| K182 Parking Assist Control Module | The assembly has several functions: Front Parking Assist Rear Parking Assist |
|
The sensors can send and receive ultrasonic sounds. First a short sound is emitted. If there is an obstacle in front of the sensor, the obstacle will reflect the sound back to the sensor. The time difference between sending and receiving is the measure for the distance to the obstacle. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.