Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (DRIVER ASSISTANCE SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESFORWARD COLLISION ALERT SYSTEM MALFUNCTIONCIRCUIT/SYSTEM TESTING
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Circuit/System Testing
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left, ignition ON.
- Verify a test lamp illuminates between the control circuit terminal 4 and ground.
- If the test lamp does not illuminate
- Ignition OFF, disconnect the X1 harness connector at the K9 Body Control Module.
- Test for less than 2 Ω in the control circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, refer to Interior Backlighting Malfunction .
- Go to next step: If the test lamp illuminates
- Connect a test lamp between the control circuit terminal 5 and the control circuit terminal 4.
- Verify the test lamp turns ON and OFF when commanding the Lane Departure Warning Indicator On and Off with a scan tool.
- If the test lamp is always OFF
- Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
- Test for less than 1 V between the voltage circuit and ground.
- If 1 V or greater, repair the short to voltage on the circuit.
- Go to next step: If less than 1 V
- Ignition OFF.
- Test for less than 2 Ω in the control circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, replace the K109 Frontview Camera Module.
- If the test lamp is always ON
- Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module.
- Test for infinite resistance between the voltage circuit and ground.
- If less than infinite resistance, repair the short to ground in the circuit.
- If infinite resistance, replace the K109 Frontview Camera Module.
- Go to next step: If the test lamp turns ON and OFF
- Test or replace the S70L Steering Wheel Controls Switch - Left.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.