Outside Rearview Mirror Replacement (Power)

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Outside Rearview Mirror Replacement (Power)
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2425022Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the front side door upper front trim panel. Refer to Front Side Door Upper Front Trim Panel Replacement .
  2. Remove the outside rearview mirror bolt access hole on the front side door trim.
1 Outside Rearview Mirror Fastener (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Procedure 
Disconnect the electrical connector.
Tighten 
10 N.m (89 lb in)
2 Outside Rearview Mirror
Procedure 
Inspect the outside mirror for proper operation before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.