Inside Rearview Mirror Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Inside Rearview Mirror Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2425033Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Inside Rearview Mirror Cover

Procedure

  1. Remove the wire harness cover, sliding the cover upward releasing the cover from the support.
  2. Disconnected the connector from the mirror base.
2 Inside Rearview Mirror Screw
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Adjust the mirror to the full upward position, loosen the screw at the base in order to remove the mirror from the button.
  2. Slide the mirror in an upward motion in order to remove.

TightenΒ 
2 N.m (18 lb in)
3 Inside Rearview Mirror
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.