Fastener Specifications

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Fastener Specifications
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Brake Pipe Fitting - Left Front, Left Rear, Right Front, Right Rear 18 N.m (13 lb ft)
Brake Pressure Modulator Valve (BPMV) Bolt 10 N.m (89 lb in)
Brake Pressure Modulator Valve (BPMV) Bracket Bolt 22 N.m (16 lb ft)
Electronic Brake Control Module (EBCM) Bolt 3 N.m (27 lb in)
Master Cylinder Primary Brake Pipe Fitting 32 N.m (24 lb ft)
Master Cylinder Secondary Brake Pipe Fitting 32 N.m (24 lb ft)
Steering Column Bracket Screw 6 N.m (53 lb in)
Vehicle Dynamic Sensor Nut 9 N.m (80 lb in)
Wheel Speed Sensor Bolt - Front and Rear 13 N.m (115 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.