Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSWHEEL SPEED SENSOR RELUCTOR RING REPLACEMENTREMOVAL PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Removal Procedure
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel) .
- Remove the rear axle housing cover. Refer to Rear Axle Housing Cover Replacement (8.6/9.5/9.7 Inch Axle)Rear Axle Housing Cover Replacement (10.5 Inch Axle) .
- Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
Using the J-45857 remover (1) and the J-2619 - 01 hammer (2), remove axle shaft seal and bearing first, then follow with removal of reluctor/wheel speed sensor ring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.