Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Installation Procedure

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Clean the sealing surfaces of the EBCM and the BPMV with denatured alcohol and allow to dry.
Inspect the EBCM to BPMV gasket for damage and replace, if necessary.
Install the EBCM (1) to the BPMV.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.