Fastener Specifications

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Fastener Specifications
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application
Windshield Garnish Molding Tether Clip
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Body Lock Pillar Upper Trim Panel Fastener 2N.m (18 lb in)
Body Side Rear Molding Fastener 2N.m (18 lb in)
Cargo Tie Down Loop Fastener 20N.m (15 lb ft)
Center Pillar Upper Assist Handle Fastener 9N.m (80 lb in)
Coat Hook Fastener 6N.m (53 lb in)
Front Side Door Armrest Bracket Fastener 2.5N.m (22 lb in)
Front Side Door Armrest Pull Cup Fastener 2.5N.m (22 lb in)
Front Side Door Inside Handle Fastener 2.5N.m (22 lb in)
Front Side Door Trim Panel Applique Fastener 1.5N.m (13 lb in)
Front Side Door Trim Panel Fastener 2.5N.m (22 lb in)
Liftgate Lower Trim Finish Panel Fastener 9N.m (80 lb in)
Rear Side Door Armrest Bracket Fastener 2.5N.m (22 lb in)
Rear Side Door Armrest Pull Cup Fastener 2.5N.m (22 lb in)
Rear Side Door Inside Handle Fastener 1.4N.m (12 lb in)
Rear Side Door Trim Panel Applique Fastener 1.5N.m (13 lb in)
Rear Side Door Trim Panel Fastener 2.5N.m (22 lb in)
Roof Rail Assist Handle Fastener 6N.m (53 lb in)
Roof Rail Rear Assist Handle Fastener 6N.m (53 lb in)
Sunshade Fastener 2.5N.m (22 lb in)
Sunshade Support Fastener 2.5N.m (22 lb in)
Windshield Pillar Assist Handle Fastener 9N.m (80 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.