Radio Antenna Amplifier Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Radio Antenna Amplifier Replacement
GM3637313Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove body lock pillar upper trim panel. Refer to Body Lock Pillar Upper Trim Panel Replacement .
  2. Remove the body lock pillar upper trim panel. Refer to Body Rear Corner Upper Garnish Molding Replacement (Standard Wheelbase)Body Rear Corner Upper Garnish Molding Replacement (Extended Wheelbase) .
  3. Lower the rear of the headliner enough to gain access to the amplifier fastener. Refer to Headlining Trim Panel Replacement (Standard Wheelbase)Headlining Trim Panel Replacement (Extended Wheelbase) , or Headlining Rear Trim Panel Replacement .
1 Radio Antenna Amplifier Fastener
CAUTION:

Refer to Fastener Caution .


TightenΒ 
5.5 N.m (49 lb in)
2 Radio Antenna Amplifier

Procedure

  1. Disconnect the electrical connection.
  2. Unsnap the wire from the glass.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.