SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSREAR CLOSURE HANDS FREE SENSOR REPLACEMENT (CADILLAC)
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Rear Closure Hands Free Sensor Replacement (Cadillac)

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Rear Closure Hands Free Sensor Replacement (Cadillac)
GM3648527Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the rear fascia. Refer to Rear Bumper Fascia Replacement (Cadillac)
  2. Place the bumper fascia face down on a clean protected surface.
  3. Remove the left rear fog lamp. Refer to Rear Fog Lamp Replacement (Cadillac)
1 Rear Bumper Fascia Lower Screw (Qty: 6)
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Rear Closure Hands Free Sensor - Lower
Procedure 
Disengage the wire at the connector, disengage opposite end, then pull back on each tab, and apply slight force on sensor to push the sensor out of the tabs and remove.
3 Rear Closure Hands Free Sensor - Upper

Procedure

  1. Disconnect the electrical connector.
  2. Reposition the upper fascia center structure for access to the upper sensor.
  3. Remove the sensor out from between the rear bumper fascia and the rear bumper fascia structure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.