Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Remove the front side door latch and door outside handle bracket assembly as one from the door. Refer to Front Side Door Latch Replacement .
- NOTE:
Its not necessary to disconnect the inside or outside handle cables to replace the door lock cylinder.
Disconnect the front side door lock cylinder rod (1) from the lock cylinder.
- Loosen the front side door outside handle lock cylinder screw.
From the back side of the outside handle bracket, use a suitable tool, push outward on the lock cylinder retainer (1) releasing the retainer from the lock cylinder (2).
With the lock cylinder retainer (1) removed, pull the lock cylinder (2) rearward releasing it from the handle bracket (3).
When performing this procedure the latch and handle bracket assembly Must be removed from the vehicle to replace the door lock cylinder assembly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.