Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019SILVERADO 1500 SSV, 4WD, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 21 (ENGINE CONTROLS AND FUEL - 2.7L (L3B) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSINTAKE AIR SPLASH SHIELD REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Silverado 1500 SSV, 4WD, Gas
Installation Procedure
2019 Chevrolet Silverado 1500 SSV, 4WD, GasSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Intake Air Splash Shield (2) - Install
- Intake Air Baffle Retainer (1) - Install [10x]
Hood Secondary Latch Release Handle (2) - Install
- Hood Latch Actuator Bolt (1) - Install and tighten [2x] - Fastener Specifications
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.