Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Transmission Control (1) - Install
- CAUTION:
Transmission Control Bolt (1) - Install and tighten [3x] 10 N.m (89 lb in)
Install the steering column.
- Steering Column Nut (1) - Install - Steering Column Replacement [4x].
- Automatic Transmission Shift Lock Control Actuator @ Transmission Control - Connect - Automatic Transmission Shift Lock Control Actuator Replacement
- Range Selector Lever Cable @ Transmission Control - Connect - Range Selector Lever Cable Replacement
Communication Interface Module Bracket - Install - Communication Interface Module Bracket Replacement
- Shift Lever - Install - Shift Lever Replacement
- Place the transmission control in the Park position.
Connect the park lock cable (2) to the ignition switch housing (1).
Instrument Panel Steering Column Lower Trim Cover (2) - Install - Steering Column Trim Cover Replacement
- Release the parking brake.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.