Installation Procedure

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
  1. GM4852315Courtesy of GENERAL MOTORS COMPANY

    Install a NEW throttle body gasket (1).

  2. GM4852314Courtesy of GENERAL MOTORS COMPANY

    Position the throttle body (2).

  3. CAUTION:

    Refer to Fastener Caution .

  4. Install the throttle body bolts (1) and tighten to 10 N.m (89 lb in).
  5. GM4852311Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector (1).

  6. Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct ReplacementΒ 
  7. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) , or Battery Negative Cable Disconnection and Connection (Dual Battery)
  8. Perform the throttle body idle air flow compensation reset. Throttle Body Idle Air Flow Compensation ResetΒ 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.