Installation Procedure

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
  1. GM4850557Courtesy of GENERAL MOTORS COMPANY

    O-Ring(2) - Install NEW

  2. Fuel Tank Fuel Pump Module(1) - Install
  3. GM4850555Courtesy of GENERAL MOTORS COMPANY

    Fuel Sender Retainer(1) - Install - CH 45722Β  Fuel Sender Lock Ring Wrench

  4. GM4850554Courtesy of GENERAL MOTORS COMPANY

    Fuel Feed Pipe(3) - Connect - Plastic Collar Quick Connect Fitting ServiceΒ 

  5. Evaporative Emission Hose(2) - Connect - Plastic Collar Quick Connect Fitting ServiceΒ 
  6. Electrical Connector(1) - Connect[2x]
  7. Fuel Tank - Install - Fuel Tank Replacement (Short Wheel Base)Β , or Fuel Tank Replacement (Long Wheel Base)Β , or Fuel Tank Replacement (Chassis Cab Rear Tank)Β , or Fuel Tank Replacement (Chassis Cab Front Tank)Β 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.