Circuit/System Description

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Circuit/System Description
WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Exhaust Aftertreatment System Description

Circuit Description
Control - Terminal 2 The output circuit is switched to 12 V to activate the component.
Control - Terminal 1 The output circuit is switched to ground to activate the component.
Component Description
Q61 Reductant Injector The reductant injector is used to dose and atomize the reductant into the exhaust system.
K115 Reductant Control Module The control module controls the heating and dosing of the reductant.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.