Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 12 (AUTOMATIC TRANSMISSION - 8L90 (M5U) - COMPONENT LOCATOR)COMPONENT LOCATORCOMPONENT LOCATION
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G
Component Location
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Component Location
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Torque Converter |
| 4 | Automatic Transmission Case Front Cover |
| 14 | Stator Shaft Support |
| 22 | Automatic Transmission Case Extension |
| 46 | Automatic Transmission Fluid Filter |
| 57 | 1-3-5-6-7 Clutch |
| 60 | 2-3-4-6-8 and 4-5-6-7-8-Reverse Clutch |
| 62 | Direct Overdrive Internal Gear |
| 64 | Direct Overdrive Carrier |
| 65 | Input Internal Gear |
| 67 | Input Carrier |
| 69 | Input Sun Gear |
| 71 | Reaction Internal Gear and 1-2-3-4-5-Reverse Hub |
| 72 | Reaction Carrier |
| 73 | Output Carrier |
| 76 | Output Shaft Seal |
| 301 | Automatic Transmission Fluid Pump |
| 315 | Control Valve Upper Body |
| 320 | Control Valve Solenoid Body |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.