Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 94 (PARKING BRAKE SYSTEM)SPECIFICATIONSFASTENER SPECIFICATIONS
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G
Fastener Specifications
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Fastener Specifications
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Parking Brake Actuator Position Switch | 4 N.m (35 lb in) |
| Parking Brake Bolt | 300 N.m (221 lb ft) |
| Parking Brake Lever Handle Bolt | 10 N.m (89 lb in) |
| Parking Brake Lever Nut | 25 N.m (18 lb ft) |
| Parking Brake Rear Cable Clip Bolt | 13 N.m (115 lb in) |
| Parking Brake Support Nut - Front | 185 N.m (137 lb ft) |
| Parking Brake Support Nut - Rear | 185 N.m (137 lb ft) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.