SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 94 (PARKING BRAKE SYSTEM)REPAIR INSTRUCTIONSPARKING BRAKE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G

Installation Procedure

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4864633

    Parking Brake Control Module (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Parking Brake Lever Nut(1) - Install and tighten[3x]25 N.m (18 lb ft)
  3. Connect the electrical connector.
  4. GM4864514

    Parking Brake Front Cable(3) - Install

  5. Parking Brake Front Cable Grommet (2) - Install
  6. Parking Brake Cable Retainer Nut (1) - Install and hand tighten
  7. Front Floor Panel Carpet - Install - Front Floor Panel Carpet Replacement
  8. GM4859484

    Floor Air Outlet Duct - Left Side(2) - Install - Floor Air Outlet Duct Replacement - Left Side

  9. GM4854633

    Body Hinge Pillar Trim Panel (1) - Install - Body Hinge Pillar Trim Panel Replacement

  10. GM4861177

    Parking Brake Lever Handle(2) - Install - Parking Brake Lever Handle Replacement 

  11. Raise and support the vehicle. Lifting and Jacking the Vehicle
  12. GM4864389

    Parking Brake Front Cable(1)@ Frame Bracket - Install

  13. Parking Brake Front Cable(1)@Parking Brake Intermediate Cable(2) - Connect
  14. Enable the park brake cable adjuster. Parking Brake Cable Adjuster Enabling 
  15. Verify that the vehicle will hold position with the parking brake pedal depressed.
  16. If additional adjustments need to be made, adjust the parking brake. Parking Brake Adjustment 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.