Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pin surfaces. Adhesives, Fluids, Lubricants, and Sealers
- Apply lubricant to the brake caliper guide pin shafts.
- Apply lubricant to the brake caliper guide pin seats.
- Apply lubricant to the brake caliper guide pin threads.
Rear Brake Caliper Guide Pin Bushing(1) - Install
- Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pins and guide pin bores.
- CAUTION:
Refer to Fastener Caution .
Rear Brake Caliper Guide Pin- Upper(1) - Install and tighten61 N.m (45 lb ft)
- Rear Brake Caliper Guide Pin- Lower(2) - Install and tighten61 N.m (45 lb ft)
Rear Brake Caliper Guide Pin Seal(2) - Install[2x] - Rear Disc Brake Mounting and Hardware Inspection (With Single Rear Wheel) Rear Disc Brake Mounting and Hardware Inspection (With Dual Rear Wheel)
Ensure the rear brake caliper guide pin seals are fully seated in the groove of the rear brake caliper housing.
- Rear Brake Caliper Guide Pin Boot(1) - Install[2x] - Rear Disc Brake Mounting and Hardware Inspection (With Single Rear Wheel) Rear Disc Brake Mounting and Hardware Inspection (With Dual Rear Wheel)
- NOTE:
Do not remove the brake caliper guide pins unless replacement is required.
Rear Brake Caliper Bracket(1)@Rear Brake Caliper - Install
Ensure the brake caliper guide pin seals are fully seated in the grooves of the brake caliper bracket.
Rear Disc Brake Pad Retainer Spring(1) - Install[4x]
Rear Disc Brake Outer Pad(2) - Install
- Rear Disc Brake Inner Pad(1) - Install
Install the rear brake caliper and bracket assembly (1). Rear Brake Caliper Replacement (JH6) Rear Brake Caliper Replacement (JH9)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.