Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Lubricate the front brake caliper bushings, bolts and seals with high temperature silicone brake lubricant. Adhesives, Fluids, Lubricants, and Sealers
Brake Caliper Guide Pin Bushing (1) - Install NEW[2x]
Brake Caliper Guide Pin Seal(1) - Install NEW[2x]
Brake Caliper(1) - Install
- CAUTION:
Brake Caliper Guide Pin Bolt(1) - Install and tighten[2x] - Front Brake Caliper Guide Pin Replacement (JH6) Front Brake Caliper Guide Pin Replacement (JH9)
- Install the front tire and wheel assemblies. Tire and Wheel Removal and Installation (Without Dual Rear Wheels)Tire and Wheel Removal and Installation (With Dual Rear Wheels)
- Remove the support and lower the vehicle.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 8 and 9 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.