Removal Procedure

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Removal Procedure
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4849296

    Auxiliary Air Conditioning Evaporator and Blower Module(1) - Remove - Auxiliary Air Conditioning (A/C) Evaporator and Blower Module Assembly Removal and Installation (C69 Passenger Van)Β Auxiliary Air Conditioning (A/C) Evaporator and Blower Module Assembly Removal and Installation (C69 Cargo Van)Β 

  2. GM4850104

    Air Conditioning Evaporator Tube seal (1) - Remove

  3. Auxiliary Air Conditioning Evaporator and Blower Module Drain Valve(2) - Remove
  4. GM4850437

    Auxiliary Air Conditioning Evaporator and Blower Module Cover(1) - Remove - Auxiliary Air Conditioning Evaporator and Blower Module Cover Replacement (C36 Cargo Van)Β Auxiliary Air Conditioning Evaporator and Blower Module Cover Replacement (Passenger Van C69)Β 

  5. GM4850460

    Auxiliary Heater Core(1) - Remove

  6. GM4852825

    Auxiliary Air Conditioning Evaporator and Blower Case- OutBoard (1)@ Auxiliary Air Conditioning Evaporator and Blower Case - Inboard (2) - Remove - Auxiliary Air Conditioning Evaporator and Blower Case Replacement - Outboard (C69)Β 

  7. GM4853629

    Mode Valve(1)@ Auxiliary Air Conditioning Evaporator and Blower Case - Outboard - Remove

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.