Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Inspect the splines of the propeller shaft slip yoke for a sufficient coating of lubricant. If the splines of the slip yoke do NOT have a sufficient coating, lubricate the internal slip yoke splines with clean transmission fluid. Adhesives, Fluids, Lubricants, and Sealers
Propeller Shaft (1) - Install
- Align the reference marks made during removal.
Propeller Shaft (1) @ Transmission Output Shaft (2) - Install
Propeller Shaft (1) @ Pinion Flange Assembly (2) - Install
Rear Propeller Shaft Retainer (2) - Install NEW retainers. Do NOT reuse old retainers. [2x]
- Rear Propeller Shaft Bolt (1) - Install NEW bolts. [4x] Tighten 25 N.m (18 lb ft)
- Lower the vehicle.
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.