SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (12 V STARTING AND CHARGING SYSTEM)REPAIR INSTRUCTIONSBATTERY REPLACEMENT (LWN)INSTALLATION PROCEDURE
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G

Installation Procedure

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4597853Courtesy of GENERAL MOTORS COMPANY

    Battery (1) - Install

  2. GM4597852Courtesy of GENERAL MOTORS COMPANY

    Battery Hold Down Retainer (2) - Install

    3. CAUTION:

    Refer to Fastener Caution

  3. Battery Hold Down Bolt (1) - Install and tighten 22 N.m (16 lb ft)
  4. GM4527822Courtesy of GENERAL MOTORS COMPANY

    Battery Positive Cable (2) - Install

  5. Battery Positive Cable Bolt (1) - Tighten 14 N.m (124 lb in)
  6. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (Single Battery) Battery Negative Cable Disconnection and Connection (Dual Battery) 
  7. GM4597509Courtesy of GENERAL MOTORS COMPANY

    Front End Sheet Metal Diagonal Brace Reinforcement (2) - Install

  8. Front End Sheet Metal Diagonal Brace Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.