SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (12 V STARTING AND CHARGING SYSTEM)REPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE REPLACEMENT (LWN)INSTALLATION PROCEDURE
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G

Installation Procedure

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4592749Courtesy of GENERAL MOTORS COMPANY

    Battery Negative Cable (1) - Install

    2. CAUTION:

    Refer to Fastener Caution

  2. Battery Negative Cable Ground Fastener (2) - Install and tighten 50 N.m (37 lb ft)
  3. GM4592748Courtesy of GENERAL MOTORS COMPANY

    Battery Negative Cable (3) - Install

  4. Battery Negative Cable Frame Ground Fastener (2) - Install and tighten 10 N.m (89 lb in)
  5. Lower the vehicle.
  6. Retainer (1) - Engage [2x]
  7. GM4592747Courtesy of GENERAL MOTORS COMPANY

    Battery Negative Cable (2) - Install

  8. Battery Negative Cable Ground Fastener (1) - Install and tighten 10 N.m (89 lb in)
  9. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) Battery Negative Cable Disconnection and Connection (Dual Battery) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.