SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROL SYSTEM)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G

Steering Wheel Control Switch Assembly Replacement

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Steering Wheel Control Switch Assembly Replacement
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
GM1915283
Callout Component Name
Preliminary Procedure 
Remove the inflatable restraint steering wheel module. Refer to Airbag Steering Wheel Module Replacement .
1 Steering Wheel Trim Plate Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Steering Wheel Trim Plate (Qty: 2)
3 Radio Control Screw (Qty: 6)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
4 Radio Control Switch Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Make sure the steering wheel control switches are properly seated to the steering wheel trim cover during installation.
5 Cruise Control Switch Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Make sure the steering wheel control switches are properly seated to the steering wheel trim cover during installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.