Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position,
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Clean the electronic brake control module and brake pressure modulator valve assembly of any accumulated dirt and debris.
Electrical Connector (1)@Electronic Brake Control Module - Disconnect
Electronic Brake Control Module Bolt (1) - Remove [4x]
- NOTE:
Do NOT lever or pry the components apart.
Electronic Brake Control Module (1) - Remove
Seal (1)@Electronic Brake Control Module - Remove
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.