Manual Mirror Replacement (DHC)

2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Manual Mirror Replacement (DHC)
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
GM2332721Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Place the window in the fully down position.
  2. Remove front door trim panel. Refer to Front Door Trim Plate Replacement .
1 Outside Rearview Mirror Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution Fastener Caution.

Procedure

  1. Take the weight off the three mirror studs using an aid to assist in holding the mirror in place, then follow the torque sequence steps below.
  2. Torque the front nut first.
  3. Torque the top nut second.
  4. Torque the rear nut last.
  5. Check static torque (should be no less then 8 N.m (70 lb in)).

TightenΒ 
10 N.m (89 lb in).
2 Outside Rearview Mirror
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.