Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 109 (AUTOMATIC TRANSMISSION - 6L90 (MYD) - COMPONENT LOCATOR)
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G
Section 109 (Automatic Transmission - 6L90 (MYD) - Component Locator)
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Section 109 (Automatic Transmission - 6L90 (MYD) - Component Locator)
WARNING: This page is about a different car, the 2018 GMC Savana 3500, 2018 GMC Savana 2500, 2018 Chevrolet Express 3500, and 2018 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Component Locator
- Disassembled Views
- Case and Associated Parts
- Clutch Assemblies and Associated Parts
- Torque Converter (w/Fluid Pump) Housing Assembly
- Control (with Body and Valve) Valve Assembly
- Upper Control Valve Body Assembly
- Lower Control Valve Body Assembly
- 1 - 2 - 3 - 4 and 3 - 5 Reverse Clutch Assembly
- 4 - 5 - 6 (w/Turbine Shaft) Clutch Assembly
- 2 - 6 Clutch Assembly
- Low and Reverse Clutch Assembly
- 4 - 5 - 6 Clutch Hub Assembly
- Output Carrier Assembly
- Output Shaft Assembly
- Park System Components
- Component Location
- Bushing, Bearing, and Washer Locations
- Seal Locations
- Ball Check Valve Locations
- Disassembled Views
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.