Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Attach the instrument panel outer air outlet duct (1) to the instrument panel extension (2).
Instrument Panel Extension(1) - Install
Instrument Panel Upper Trim Panel(1) - Install
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Upper Trim Panel Bolt(1) - Install and tighten 2.5 N.m (22 lb in)
- Instrument Panel Extension Bolt(2) - Install and tighten [2x] 2.5 N.m (22 lb in)
Windshield Garnish Molding(3) - Install - Windshield Garnish Molding Replacement
Instrument Panel Cluster Trim Plate(1) - Install - Instrument Panel Cluster Trim Plate Replacement
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.