Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCOMPONENT CONNECTOR END VIEWS (A3L-B153P)COMPONENT CONNECTOR END VIEWSA10 INSIDE REARVIEW MIRROR (UEU/UFL)
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G
A10 Inside Rearview Mirror (UEU/UFL)
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION A10 Inside Rearview Mirror (UEU/UFL)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray Name | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | 13575742 | J-35616-64B (LT BU) | J-38125-215A | SAIT-A03T-M064 | Yazaki 14 | P | P |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.5 | GN/WH | 24 | Backup Lamp Control | I | - |
| 2 | 0.5 | VT/WH | 239 | Run/Crank Ignition 1 Voltage | I | - |
| 3 - 4 | - | - | - | Not Occupied | - | - |
| 5 | 0.5 | BK/WH | 351 | Signal Ground | I | - |
| 6 | 0.5 | BU | 7641 | Camera Rear Vision Signal + | I | - |
| 7 | 0.5 | WH | 7642 | Camera Rear Vision Signal (-) | I | - |
| 8 - 10 | - | - | - | Not Occupied | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.