Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Body Mount Upper Cushion (4) - Install
- Raise the frame (5).
- Body Mount Lower Cushion (3) - Install
- Body Mount Retainer (2) - Install
- Body Mount Bolt (1) - Install and tighten140 N.m (103 lb ft)
- NOTE:
Do not remove the bolts.
Body Mount Bolt (1) - Tighten140 N.m (103 lb ft)[14x]
Lower Intermediate Steering Shaft (1)@Steering Gear - Install - Lower Intermediate Steering Shaft Replacement
- Remove the safety stands.
- Lower the vehicle.
- Install the screws retaining the fuel tank filler pipe to the body.
- For the LV1 engine - Fuel Tank Filler Pipe Replacement (Chassis Cab Front Tank) , or Fuel Tank Filler Pipe Replacement (Chassis Cab Rear Tank) , or Fuel Tank Filler Pipe Replacement (Short/Long Wheel Base)
- For the L96, LC8 engine - Fuel Tank Filler Pipe Replacement (Passenger/Cargo) , or Fuel Tank Filler Pipe Replacement (Chassis Cab Front Tank) , or Fuel Tank Filler Pipe Replacement (Chassis Cab Rear Tank)
- For the LWN engine - Fuel Tank Filler Pipe Replacement
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.