Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Position the dome and reading lamp (1) near the headliner opening.
- Connect the electrical connector.
- Insert the lamp housing arm at the right side above the headliner.
- While tilted down on the left side, insert the dome lamp (1) up and to the right.
- NOTE:
The lamp lens arm on the left side is designed to hold the lamp in position when the lens is fully closed.
Install the left arm of the lens (1) through the lamp and headliner opening, simultaneously lifting the lamp up and close the lens (1).
- Make sure the tab of the lens (1) has snapped back into the fully seated position.
- Install the headlining front trim panel. Headlining Front Trim Panel Replacement
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.