Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019EXPRESS 2500 BASE, VAN CARGO EXTENDED, 6.0L ENG VIN GREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMREPAIR INSTRUCTIONSCARGO CENTER COURTESY LAMP REPLACEMENTREMOVAL PROCEDURE
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN G
Removal Procedure
2019 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GSECTION Removal Procedure
- Using a flat bladed tool, push the tab inward and open the lens (1).
While opening the lens, simultaneously pull the left side down slowly to allow the lens arm to pass by the headliner opening.
- While tilted down on the left side, move the dome lamp (1) to the left far enough for the lamp arm to pass by the headliner on the right side.
- Lower the dome lamp (1) far enough to gain access to the connector.
- Disconnect the electrical connector.
- Transfer parts as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.