Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019CRUZE LS, 4D HATCHBACKREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATOR - INSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSINSTRUMENT PANEL COMPONENTS
2019 Chevrolet Cruze LS, 4D Hatchback
Instrument Panel Components
2019 Chevrolet Cruze LS, 4D HatchbackSECTION Instrument Panel Components
Instrument Panel Components
| Items |
|---|
| 1. P16 Instrument Cluster P16 Instrument Cluster |
| 2. B10B Ambient Light/Sunload Sensor B10B Ambient Light/Sunload Sensor |
| 3. A11 Radio (IOR) A11 Radio X1 (IOR)A11 Radio X2 (IOR)A11 Radio X3 (IOR)A11 Radio X4 (IOR)A11 Radio X6 (IOR)A11 Radio X7 (IOR) |
| 4. A26 HVAC Controls A26 HVAC Controls |
| 5. S82 Windshield Wiper/Washer Switch S82 Windshield Wiper/Washer Switch |
| 6. X85 Steering Wheel Air Bag Coil X85 Steering Wheel Air Bag Coil X1X85 Steering Wheel Air Bag Coil X2 |
| 7. K89 Immobilizer Control Module K89 Immobilizer Control Module (-AVJ-BTM)K89 Immobilizer Control Module (AVJ/BTM) |
| 8. S39 Ignition Switch S39 Ignition Switch |
| 9. S78 Turn Signal/Multifunction Switch S78 Turn Signal/Multifunction Switch |
| 10. S30 Headlamp Switch S30 Headlamp Switch |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.