Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Key with Integrated Transmitter Programming (without BTM, with Fixed Key Blade): Notes
Transmitters can be programmed in various ways using the adding or replacing keys procedures outlined below. The transmitter with the key blade installed is required for programming. The key blade must be removed and properly disposed of after the procedure is completed. Do not allow the customer to have the transmitter with the key blade installed.
Using the Replacing Keys procedures will first erase all the known keys from the vehicle. Any existing keys and any new keys will then be programmed. This procedure is typically used any time a key is required to be unlearned or erased from a vehicle. If a new key is being learned to a vehicle to replace a damaged, inoperative, or stolen key, the Replacing Keys procedure is often used. This ensures that the old key cannot be used to access or start the vehicle after programming.
The Adding Keys procedure does not erase any keys prior to programming. The procedure will simply program the key into the next available slot. The Adding Keys procedure should be used when adding an additional key to the vehicle.
When the Replacing Keys procedure is performed, all existing keys and transmitters will be erased. There will be no way to add any existing transmitters back to the vehicle because the key blade has been removed. The customer will have to purchase a new transmitter.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.