Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019CORVETTE Z06, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, STARTING SYSTEM AND CHARGING SYSTEMREPAIR INSTRUCTIONSSTARTER REPLACEMENTREMOVAL PROCEDURE
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic Trans
Removal Procedure
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic TransSECTION Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- { If equipped }Engine Oil Level Indicator Switch - Disconnect - Engine Oil Level Indicator Switch Replacement
Starter Heat Shield Fastener (1) - Remove [3x]
- Starter Heat Shield (2) - Remove
- NOTE:
Catalytic converter is removed for graphic clarity.
Starter Solenoid Cable Nut (2) @ Starter Solenoid (3) - Remove
- Starter Solenoid Cable (1) - Remove
Starter Mounting Bolt (1) - Remove [2x]
- Reposition the starter (2) to access the electrical connector.
Electrical Connector (1) - Disconnect
- Starter (2) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.