Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019CORVETTE Z06, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALWIRING SYSTEMS AND POWER MANAGEMENT - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSREAR BODY FUSE BLOCK REPLACEMENT (COUPE)REMOVAL PROCEDURE
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic Trans
Removal Procedure
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic TransSECTION Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Rear Body Fuse Block Cover (1) - Remove
- Battery Positive Cable Nut (3) - Remove
- Battery Positive Cable (2) - Remove
- Body Harness Terminal Fastener (4) - Remove [2x]
- Body Harness Terminal (5) - Remove [2x]
Battery Positive Post Clamp Nut (2) - Loosen
- Retainer (3) - Disengage [2x]
- Rear Body Fuse Block (1) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.