Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019CORVETTE Z06, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTIMAGE DISPLAY CAMERA SYSTEMREPAIR INSTRUCTIONSVIDEO PROCESSING MODULE REPLACEMENT
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic Trans
Video Processing Module Replacement
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic TransSECTION Video Processing Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Rear Compartment Floor Panel Trim Replacement (North America)Rear Compartment Floor Panel Trim Replacement (Export - CU9, CV5, CZ3, C4E) |
|
| 1 | Video Processing Module Nut[3x]
CAUTION:
Procedure Remove wire harness retainer push clip from bracket. Tighten 9 N.m (80 lb in) |
| 2 | Video Processing Module Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.