SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019CORVETTE Z06, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSHUMAN MACHINE INTERFACE CONTROL MODULE REPLACEMENT
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic Trans

Human Machine Interface Control Module Replacement

2019 Chevrolet Corvette Z06, 2D Coupe, Automatic TransSECTION Human Machine Interface Control Module Replacement
GM3396141Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel driver knee bolster deflector bracket. Refer to Instrument Panel Driver Knee Bolster Deflector Bracket Replacement .
  2. Remove the instrument panel insulator panel - left side. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
1 Human Machine Interface Control Module

Procedure

  1. Disconnect the electrical connections.
  2. Release bracket tabs and slide module downward to release.
  3. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.