SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019CORVETTE Z06, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE REPLACEMENT
2019 Chevrolet Corvette Z06, 2D Coupe, Automatic Trans

Communication Interface Module Replacement

2019 Chevrolet Corvette Z06, 2D Coupe, Automatic TransSECTION Communication Interface Module Replacement
GM3391402Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel insulator panel - right side. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
  2. Remove the front side door sill garnish molding - right side. Refer to Front Side Door Sill Garnish Molding Replacement (Left Side)Front Side Door Sill Garnish Molding Replacement (Right Side) .
  3. Remove the communication interface module battery. Refer to Communication Interface Module Battery Replacement .
  4. Remove the fasteners for the communication interface module bracket. Refer to Communication Interface Module Bracket Replacement  and reposition the bracket for module removal.
1 Communication Interface Module

Procedure

  1. Disconnect the electrical connectors.
  2. Slide the module from the bracket tabs to remove.
  3. For programming and set up, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.