Fastener Specifications

2019 Chevrolet Blazer Premier, FWDSECTION Fastener Specifications
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Intermediate Steering Shaft Lower Bolt 42 N.m (31 lb ft)
Intermediate Steering Shaft Upper Bolt 42 N.m (31 lb ft)
Steering Column Lower Trim Cover Bolt 2.5 N.m (22 lb in)
Steering Column Nut
Refer to procedure for tightening sequence and torque values.
Steering Column Replacement (N37)Β , or Steering Column Replacement (N38)Β 
Steering Column Tilt Wheel and Telescope Control Module Bolt 3 N.m (27 lb in)
Steering Wheel Bolt 45 N.m (33 lb ft)
Steering Wheel Rear Switch Screw 3.5 N.m (31 lb in)
Steering Wheel Screw 1.1 N.m (10 lb in)
Steering Wheel Spoke Cover Screw 1.1 N.m (10 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.