Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019BLAZER PREMIER, FWDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING WHEEL AND COLUMNREPAIR INSTRUCTIONSSTEERING COLUMN LOWER TRIM COVER REPLACEMENT (N37)REMOVAL PROCEDURE
2019 Chevrolet Blazer Premier, FWD
Removal Procedure
2019 Chevrolet Blazer Premier, FWDSECTION Removal Procedure
- Extend the steering column to its furthest point to allow the steering column lower trim cover to clear the instrument panel knee bolster.
Steering Column Lower Trim Cover Bolt (1) - Remove [3x]
- Rotate the steering wheel left and right to access the fasteners securing the lower trim cover to the turn signal switch bracket.
- Use a flat bladed plastic trim tool to release the steering column upper trim cover from the steering column lower trim cover (2) and position out of the way.
- Steering Column Lower Trim Cover (2) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.