Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019BLAZER PREMIER, FWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSVEHICLE ACCESS SYSTEMSPECIFICATIONSFASTENER SPECIFICATIONS
2019 Chevrolet Blazer Premier, FWD
Fastener Specifications
2019 Chevrolet Blazer Premier, FWDSECTION Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Side Door Latch Bolt | 9 N.m (80 lb in) |
| Front Side Door Latch Screw | 11 N.m (97 lb in) |
| Front Side Door Lock Cylinder Opening Cover Screw | 4.7 N.m (42 lb in) |
| Front Side Door Lock Striker Screw | 22 N.m (16 lb ft) |
| Front Side Door Outside Handle Bracket Screw | 4.7 N.m (42 lb in) |
| Liftgate Latch Bolt | 22 N.m (16 lb ft) |
| Liftgate Latch Striker Bolt | 22 N.m (16 lb ft) |
| Rear Closure Hands Free Module Bolt | 2.5 N.m (22 lb in) |
| Rear Side Door Latch Bolt | 9 N.m (80 lb in) |
| Rear Side Door Latch Screw | 11 N.m (97 lb in) |
| Rear Side Door Lock Cylinder Opening Cover Screw | 4.7 N.m (42 lb in) |
| Rear Side Door Lock Striker Screw | 22 N.m (16 lb ft) |
| Rear Side Door Outside Handle Bracket Screw | 4.7 N.m (42 lb in) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.