Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Opening the Liftgate Without Electrical Power
- NOTE:
Gain access to the liftgate from inside vehicle.
Using a flat bladed tool, release the latch cover (1) to access the rear latch.
- NOTE:
- Gate may not open at this point.
- Rotation to release latch should be approximately 30 degrees. Excessive rotation can cause damage to the latch.
Insert a flat bladed service type tool into the square hole (1) and turn it counterclockwise until the primary latch releases.
- NOTE:
The latch does not need to be restaged.
To disengage the gear train of the latch, use a small flat blade tool to push the white plastic lever (1) all the way to the right and at the same time pushing on the liftgate to release the secondary latch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.