Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Garage Height Calibration
If any portion of the power liftgate assembly is replaced, repaired or disassembled, perform the following liftgate relearn procedure:
- Ensure that the rotary switch on the overhead console or driver door panel is set to 3/4.
- Press the liftgate handle switch and allow the liftgate to power open.
- Stop movement at the desired height by pressing any operation switch.
- If required, manually move the stopped liftgate to the desired position.
- Press and hold the liftgate close switch for at least 3 seconds. The tail lights will flash if the setting has been successfully programmed.
- Close the liftgate completely using one of the following switches:
- The rotary switch on the overhead console or driver door panel
- The liftgate close switch on the liftgate
- The remote control switch on the keyless entry transmitter
The opening height of the liftgate should be positioned approximately parallel with the roof, the liftgate control module will reject the setting if the liftgate is positioned too low.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.