Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Front Side Door Access Hole Cover (1) - Remove
- USE HAND TOOL ONLY. Using a battery operated gun or power tool can BREAK the component.
- Around 10 - 12 rotations is enough to allow the Front Side Door Outside Handle Lock Cylinder to be removed.
- Front Side Door Outside Handle Lock Cylinder Screw (2) - Loosen
Pull the door handle (1) out to the open position.
Front Side Door Lock Cylinder Bezel (1) - Remove
Using the appropriate tool, remove the front side door lock cylinder opening cover (1) from the lock cylinder insulator. (2)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.