Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018TRAVERSE LS, 4WDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B3938CIRCUIT/SYSTEM DESCRIPTION
2018 Chevrolet Traverse LS, 4WD
Circuit/System Description
2018 Chevrolet Traverse LS, 4WDSECTION Circuit/System Description
For an overview of the component/system, refer to: Fuel Fill Door Description and Operation
| Circuit | Description |
|---|---|
| Control - Relay Coil | The output circuit is switched to 12 V to activate the component. |
| Control - Terminal 1 @ M97 Fuel Fill Door Lock Actuator | The output circuit is switched from ground to 12 V to activate the component. |
| Control - Terminal 2 @ M97 Fuel Fill Door Lock Actuator | The output circuit is switched from ground to 12 V to activate the component. |
| Ground - Relay Coil | Chassis Ground |
| Component | Description |
|---|---|
| M97 Fuel Fill Door Lock Actuator | The fuel fill door lock actuator is a bidirectional DC motor that locks/unlocks the door. |
| X53A Fuse Block - Rear Body | The fuse block houses various fuses and relays. |
| K9 Body Control Module | The module controls various vehicle functions like lighting, central door locking, power windows, etc. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.